Shoe Colouring Kit

Step 1. Preparation

• Clean the shoes thoroughly with a good leather cleaner.
• After cleaning, take the small abrasive pad, soak it in water and rub down the entire surface of the leather (note: some of the colour may be removed in this process; this is normal). Pay particular attention to any creased or cracked areas.
• On older shoes, there may be some rough or scuffed areas, simply sand these down with 1200 grit wet and dry sandpaper until smooth.
• Wipe down the leather with a damp cloth, once this is done, then leave to dry.

Step 2. Colouring

• Shake the bottle of Shoe Colourant well.
• Apply a small amount of colourant onto the sponge and rub directly onto the surface of the item using a circular motion.
• Leave this to dry thoroughly (a hairdryer can be used to speed up this process). When this is dry, apply a second coat in the same way.
• Apply a third coat by dabbing the colour onto the item with the sponge. This will ensure the colour is more uniform. If you are changing the colour, rather than restoring, additional coats may be required to achieve the desired colour.
• The leather can be sanded between coats for a smooth finish, though it is important to ensure each coat has completely dried before sanding.

Suede/Nubuck

Step 1. Preparation

• Use the abrasive pad to gently rub over the entire surface of the suede/nubuck and clean the shoes thoroughly with a good suede cleaner, then rub down with a damp cloth to remove any residue. Allow the item to dry,
• Gently rub the entire surface over again with the abrasive pad to raise the nap and wipe the surface with a clean, dry cloth to remove any dust.

Step 2. Colouring

• Dilute the Shoe Colourant, 1 part colourant to 1.5 parts water (e.g 50ml colour to 75ml water) and mix thoroughly.
• Apply the diluted colour to the sponge and use this to rub it into the suede in a circular motion, covering the fibres from all directions.
• Allow to dry, then brush the fibres with the abrasive pad to raise the nap. If required, apply a second coat in the same manner to create a more even finish and allow time to dry.
• During the colouring process the nap of the suede/nubuck may become flattened. You can raise the nap again by brushing with the abrasive pad as before.

Fabric/Satin/Canvas

Step 1. Preparation

• Shoe colourant is suitable for use on any absorbent fabric. Test your fabric with water before use to verify its absorbency.
• Thoroughly clean the item with a specialist fabric cleaner.
• Rub the fabric down with a damp cloth to remove any residue and leave to partially dry.

Step 2. Colouring

• Dilute the Shoe Colourant, 1 part colourant to 1.5 parts water (e.g 50ml colour to 75ml water) and mix thoroughly.
• Apply the diluted colour to the sponge and rub it into the fabric, covering the entire area.
• Once the entire area is covered, leave it to dry.
• Additional coats can be applied, if required, to give depth of colour or a more even finish.