Product Description
The leather finishes have been designed to seal in and protect leather. These are the same finishes applied to leather when it is manufactured to seal in the dye or pigment and to protect it from its surroundings.
Uses
1. Seal in leather that is starting to fade and wear.
This is very common with chesterfields and antiqued finished leather. The top coat wears away quite quickly with use, exposing the bright colour beneath. If you apply this product every 2 or 3 years it will prevent this from happening. On all other leathers you can use this kit to further seal the leather in the areas of high use (e.g. Car Bolster or Seating Panels), this will prevent the coatings from wearing away as quickly.
2. Change the shine.
The leather finish is available in matt, semi-matt, satin semi-gloss and gloss, so if your leather is looking dull and you want it to shine use the gloss to put some life back into the leather. Or if you prefer your leather matt, use the matt finish to kill the shine.
3. Preventing wear & tear.
Really useful for car seat bolsters or other areas that come under extreme wear & tear. By applying 3 coats of finish you are further sealing the leather in, and so reducing the chances of colour wearing off.
Instructions
1. Clean the leather first before using the kit, this is to ensure the Leather Finish will adhere properly. If the leather isn't too dirty use a damp cloth to dust off any dirt, or for dirty leather, use the Leather Ultra Clean to give it a good clean.
2. Set the airbrush up and spray one thin coat of Leather Finish onto the leather. A thin coat will make the surface look slightly wet, but not so much so that it runs. Once the Finish has been sprayed on, leave it to dry for 30 minutes or use a hair drier to dry it instantly.
3. Once the finish is dry to the touch, leave it for 10 minutes and then buff it over with a soft cotton cloth to remove any roughness.
4. Repeat steps two and three one more time.
5. Once the leather has been properly finished. Leave it to thoroughly cure for 24 hours. After 7 days, a coat of Leather Protection Cream can then be applied for maintenance.
Contents
Each kit comes with the following;
-
Airbrush
-
Airbrush Propellant Can
-
Leather Finish (in a finish of your choice)
.
Coverage & Shelf Life
Small Kit: There is enough in the small kit to apply to any item of leather up to the size of a large 2 seater sofa.
Large Kit: The large kit contains enough of each product to do an area of leather up to the size of a three piece suite.
The products supplied are specially treated to resist bacterial growth and will safely last 5 years if stored in a cool cupboard with the lid fastened.
Prices
We Ship World Wide - Postage Calculated on Checkout | 
